Energy UNITS FOR LIFT TABLE one
Basic Description
This energy unit is intended solely to the modest lift table,Consisting of higher pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This power unit continues to be extensively utilized while in the business of logistic gadgets which include minifork lift, scissors lift and ariel functioning platforms. The lower-ing motion is managed through the solenoid valve together with the speed managed by the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Common Description
This energy unit is intended exclusively for the medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The reducing movement is actived by the solenoid valve and also the velocity controlled from the adjustable needle valve. When the lift rises to a high positoin, however the electrical power provide is minimize, the decreasing motion is managed through the manual override perform.
Energy UNITS FOR LIFT TABLE three
Standard Description
This electrical power unit is intended exclusively to the huge lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing motion is actived by the solenoid valve plus the velocity controlled by a pressure compensated movement management valve.
Electrical power UNITS FOR LIFT TABLE 4
Standard Description
This energy unit is created solely to the significant lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve as well as 
velocity controlled by the adjustable needle valve. Once the lift rises to a substantial positoin, but the energy supply is cut, the reducing motion is controlled from the manual override function.
Distinctive Notes
one. This power unit is of S3 duty cycle, which may only do the job intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean every one of the hydraulic elements concerned before installation of the power unit.
3. Viscosity from the oil shoud be 15~46 cst,which really should also be clean and no cost of impurities.N46 hydraulic oil is recommended.
four. Oil transforming is needed after the initial 100 operation hours,afterwards when just about every 3000 hrs.
5. The power unit shown is created to be mounted vertically.
